Audio
      Back to home
      1. LEIGHTRONIX Knowledge Base
      2. UltraNEXUS-HD
      3. Audio

      Adjusting Record Preset Audio Settings

      Read the article below for instructions to adjust the audio type to analog, AES, or embedded SDI audio for recording with an UltraNEXUS-HD series server.

      1. In the WinLGX software, click on the System Configuration folder on the right side of the schedule editor window to display the UltraNEXUS-HD series System Configuration View windows.
      2. In the Resource View window, click on the Internal Video Record icon.
      3. In the Properties View window below, set the Record audio source field to the desired audio type (There are three presets – Good, Better, Best).
      4. From the Record Audio Source drop-down, select the type of audio signal your system is set up to record.
        • Analog: corresponds to the analog audio inputs on the UltraNEXUS-HD series video server's back panel terminal blocks (See the "Audio Terminal Blocks" knowledge base article on how to wire).
        • AES: corresponds to the AES audio inputs on the UltraNEXUS-HD series video server's back panel terminal blocks (See the "Audio Terminal Blocks" knowledge base article on how to wire).
        • Embedded 1-2, "Embedded 3-4," "Embedded 5-6," and "Embedded 7-8": if your audio is embedded within the incoming video signal, select the embedded audio channel pair that you want to record (in most cases it would be "Embedded 1-2").
      5. Save the schedule to your PC, and then send the schedule to your UltraNEXUS-HD unit to apply the changes.